Actual product photo
Safe. Simple. Secure.
TecHold
Cable Fasteners.
Switching takes confidence. See how TecHold supports cable and keeps hands clear of hammer strikes, then consider a Starter Pack.
- USA
- Made in
- 1
- Dispenser per pack
- $6
- Packs from
The TecHold system
Two packs. One smarter solution.
Made in the USAStarter Pack
Enough to try it out — we know you're going to like it!
50 fasteners + 1 dispenser
Made in the USAContractor Pack
Enough for a 1,500 sq. ft. residential home (depending on ceiling height and number of interior walls).
250 fasteners + 1 dispenser
Designed around the installer
Less hassle.
More protection.
Safer for the installer
The dispenser/holder gives extended reach and keeps fingers away from hammer strikes.
Safer for the wiring
Stand-off design holds cable off the surface, protecting it from protruding nails.
Install from the floor
Put up most in-wall supports before cable installation begins — no aggressive hammering.
Made in the USA
As used in the HGTV Urban Oasis Home 2017.
Who it's for
Built for the people who wire homes.
Residential electricians
Rough-in new homes faster, with fewer nail strikes and callbacks.
Low-voltage installers
Keep data, security, audio and TV cable neat and protected.
Builders & contractors
Stock crews in bulk with reduced rates on large orders.
Remodelers & DIYers
Finish basements and additions with a safer alternative to staples.
Why switch
TecHold vs. staples.
| TecHold | Staples | |
|---|---|---|
| Cable protection | Stand-off design holds cable off the surface, away from nails | Cable pinned flat against the stud |
| Installation | Most supports go up from the floor, before cable is run | Each staple hammered in by hand, often on a ladder |
| Installer safety | Dispenser keeps fingers away from hammer strikes | Fingers hold small staples next to the hammer |
| Cable damage | No aggressive hammering on the cable | Over-driven staples can crush cable |
How it works
Three steps. No staples.
- 01
Load the dispenser
Place a TecHold fastener in the dispenser/holder tool.
- 02
Mount from the floor
Use the dispenser's reach to install supports before cable is run.
- 03
Run your cable
Lay cable into the stand-off fasteners, held clear of the surface.
On the job
See it in action.
TecHold electrical cable fasteners provide a new and easy solution for installing cable supports versus traditional stapling.
About TecHold
For your next project
Get in touch with us!
If you have questions about purchasing TecHold products or need to place a large order, please reach out to us. We can offer reduced rates for large orders.